Icom AT-141 - Manual (Page 7)

4
2
INSTALLATIONS
■ PL-259 connector
q Slide the coupling ring over the coaxial cable. Strip
the cable jacket and pull back to reveal 10 mm of
braid.
• Soft solder the exposed braid and then pull out the jacket.
w Strip the cable as shown below. Soft solder the cen-
ter conductor the entire length of the exposed braid.
e Slide the connector body over the cable and sol-
der as shown below.
r Screw the coupling ring onto the connector body.
Solder Solder
1–2 mm
10 mm soft solder
10 mm 3 ⁄ 8 inches
Coupling 30 mm
10 mm (soft solder)
■ Mounting
Attach the AT-141 either horizontally or vertically with
one of the water drains facing downwards. After
mounting, remove the screw in the water drain.
Mounting on a Mast/Metal pole
Mounting on a flat surface
Nut
Spring
washer
Flat
washer(L)
Flat
washer(L)
Hex head
bolt
Drill a hole here
Diameter:7–8 mm;
9 ⁄ 32 – 5 ⁄ 16 inches
Weatherproof cap
Flat
washer(S)
Using self-tapping
screws Using nuts and bolts
WARNING: Mount the AT-141 securely with the
supplied nuts and bolts. Otherwise, vibrations and
shocks due to waves, etc. could loosen the antenna
tuner making if fall, causing personal injury.
Using U-bolts
U-bolt
U-bolt plate
Flat washer(L)
Spring washer
Nut
Mast/
Metal pole
Flat washer(S)
AT-141_0.qxd 05.12.1 11:06 Page 4