InStep SB150 - Manual (Page 3)

3
To lower belly bar pull forward on the spring
loaded latches (located on each side of the belly
bar) then tilt down (Picture D).
Step 2. Rear Wheel Asembly
Push the wide end of the white retaining clip
onto one end of the axle until it snaps into the
groove. Press black cap onto retaining clip. Slide
one rear wheel on the axle and insert the other
end of the axle through both of the rear support
holes (Picture E). Place the other rear wheel
onto the axle (Picture F). Snap the retaining clip
onto the axle then press on black cap onto clip
(Picture G).
Step 3. Canopy Assembly
Place the canopy so that the rounded edge is
positioned behind the headrest, then snap it onto
the back of the headrest. Bend the canopy and
snap both sides onto the belly bar (Picture H).
Assembly is now complete!
D
E
F
H G
Locking Peg
Side Latches
(not latched)
Spring Latches
for Belly Bar
Cap over
Retaining Clip
Rear Wheel
Rear Support
Hole
Axle
Rear Support
Hole
Rear Wheel
Rear Axle
Rear Brake
Cap
Retaining Clip
Rear Wheel
Head
Rest
Snap
Side Latches
Latched
Belly Bar Snap