InSinkErator MS - Manual (Page 10)

10
MS-6 Wiring Diagram
P/N 14356B
380/460 V
3-phase
1/2 to 10 HP
Call Toll Free 1-800-845-8345
for the nearest InSinkErator
Authorized Service Agency or
to reach Technical Support.
ELECTRICAL SHOCK
• Turn off the electrical supply to the disposer before
attempting any work on it. Use a voltmeter or
circuit tester to ensure that power is off.
• Installation must conform to local electrical codes.
• All control centers and disposers must be carefully
and permanently grounded.
• A properly fused disconnect must be installed at
the electrical supply source for the control center.
PROPERTY DAMAGE
• Ensure that the control center voltage and phase
match the disposer motor and electrical supply.
Check nameplates on disposers and control
centers for voltage and phase specification.
• The disposer motor wiring connection is shown in
the disposer terminal box.
-2
-1
1L
1
3L
2
5L
3
13
N
O
2T
1
4T
2
6T
3
14
N
O
A
2
11
2 A
1
A
2
-4
-3
L1 L2 L3
WATER SOLENOID VALVE
DISPOSER
MOTOR
1
L1 L2
INCOMING
POWER
SUPPLY
TO
PANEL
GROUND
L3
2 3 10 11 12
4 7 5 8 6 9