InSinkErator MS - Manual (Page 3)

Features/Mounting the Control Center
3
INTRODUCTION
The MS Control Center is UL ® and CUL ® approved for
use with InSinkErator Foodservice Disposers. See
Table 1 for approved disposer and control center
combinations. The control center operates the disposer.
Its main functions are:
• To start and stop the disposer.
• To start the water flow to the disposer.
Model Waste Disposer Model
MS-4
MS-5 SS50-26, SS75-27, SS100-28, SS125-25,
SS150-34, SS150-38, SS200-27, SS200-31
MS-5 SS50-27, SS75-28, SS100-29,
SS125-26, SS150-36, SS150-39,
SS200-29, SS200-32, SS300-25, SS300-27,
SS500-28, SS500-29, SS500-30
MS-6 SS50-27, SS75-28, SS100-29,
SS125-26, SS150-36, SS150-39,
SS200-29, SS200-32, SS300-25,
SS300-27, SS500-28, SS500-30, SS750-13,
SS750-15, SS1000-10, SS1000-11, SS1000-12
Model Part No. Voltage Phase HP
MS-4 14356 120V 1 1/2-2
MS-5 14356A 208-230V 1 1/2-2
MS-5 14356A 208-230V 3 1/2-5
MS-6 14356B 380/460V 3 1/2-10
FEATURES
ENCLOSURE
NEMA 4 construction.
PUSH BUTTON OPERATION
Push Green button to start disposer. Push Red button to
stop disposer.
PROPERTY DAMAGE
Use of more than two solenoid valves will affect
the overall function of the MS control center. Extra
solenoid valves will cause a reduction in voltage and
solenoid actuation will not occur.
Table 1. Approved Disposer and Control Center Combinations
Table 2. Electrical Specifications
MOUNTING THE CONTROL CENTER
Use the flanges at the back of the control center
enclosure and only mount panel in the upright vertical
position. See Figure 1.
Locate control center within sight of disposer per local
codes. Locate any remote control station within sight of
disposer per local codes.
If box is mounted to the sink table, recess the box so
that the buttons do not extend beyond the table's edge.
Figure 1. Control Center Dimensions