ILY Enterprise CD/DVD Duplicator - Manual (Page 5)

Copyright © 2005 by ILY Enterprise, Inc. All Rights Reserved.
4. HARDWARE INSTALLATION GUIDE
This section will show you how to set IDE devices as the Optical READER, WRITERS, and Hard Drives. The system
will auto detect your drives and assign Drive numbers.
READER WRITER HDD System Setting Information
1 Installed Installed No After you turn on the machine, the system will automatically detect
and assign the READER drive as the Source Reader and set as
Drive #1. All WRITERS will be set numbered by sequence after the
READER drive, beginning from Drive#2, Drive#3, etc.
2 No Installed No After you turn on the machine, the system will automatically assign
the WRITER drive connected to Port#1 of the controller as the
Source Reader and set as Drive#1. The rest of the WRITERS will
then be set as Writers and will be assigned numbers following their
sequence beginning from Drive#2 onwards.
3 No Installed Installed After you turn on the machine, the system will automatically assign
the WRITER drive connected to HDD the Source Reader function.
It will be assigned Drive#1. Then, the rest of the WRITERS will be
set as Writers and assigned numbers in sequence beginning from
Drive#2, Drive#3, etc.
4 Installed Installed Installed When all Drives are installed, make sure the READER drive is
connected to the HDD. The READER will be set as the Source
Reader and be assigned as Drive#1. WRITERS will be set as
Writer and assigned number by sequence from Drive#2, Drive#3,
etc.
5. LCD FRONT PANEL
1. Control Buttons
There are 4 control buttons: , , OK Cancel
: UP; Backward; Use this button to navigate backward in the menu.
: Down; Forward; Use this button to navigate forward in the menu.
OK : OK, Enter, Execute the function
Cancel : Escape, Go back to previous function
2. LCD Display
The LCD display is a 2x16 Mono LCD screen. The system will display function information, messages, and instructions
on the LCD.