Image IMHS81590 - Manual (Page 7)

7
1. Before beginning assembly, be sure that you
have read and understand the information in the
box above and on the previous page.
Place the Surround Bottom (45) and the pre-
attached Spa Surround (9) on the ground in the
location chosen for assembly. Unfold the Spa
Surround until it is round.
Open the Inflatable Liner (29). Lay the floor (the side
with the triangular pattern) of the Inflatable Liner on
the bottom of the Spa Surround (9). Pull the liner
wall up, making sure that the three holes in the Liner
position the three holes in the cutout in the Spa
Surround (see drawing 1A).
Attach the flap on the top edge of the Inflatable Liner
(29) to the fastener strip on the edge of the wood
surround (see drawing 1B). Make sure that you pull
the flap tight as you go around. Start the flap where
the fastener strip starts. Make sure all three holes in
the Inflatable Liner are visible in the cutout space in
the Spa Surround (9), as shown in drawing 1A.
1
29
Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
¥ Assembly requires the included air pump.
¥ Read each assembly step before you begin.
¥ During assembly, make sure that all parts are ori-
ented as shown in the drawings.
9 45
Holes
Cutout
Fastener
Strip
Assembly
1A
1B
Schematic View from the Outside
Cutout Wood Surround
Wood Surround
Inflatable Liner
Bolster
Flap
Fastener Strip
Cross Section
Holes in Inflatable Liner