Image IMHS81590 - Manual (Page 8)

8
2. Orient the dry side jet pack (A) as shown and posi-
tion it next to the three holes in the Inflatable Liner
(29).
Attach the Temperature Probe Assembly (30) to the
small hole in the Inflatable Liner (29). To do this,
place the Temperature Probe Gasket (46) over the
Probe connector threads. Insert the wire (not shown)
through the hole, then push the Temperature Probe
through the hole. Make sure the threads on the con-
nector have been pushed fully through the vinyl liner.
Thread the Temperature Probe Nut (47) onto the
connector and make sure it is tight. Connect the wire
from the Temperature Probe to the receptacle on the
dry side jet pack (A).
3. Move the dry side jet pack (A) up against the wall of
the tub. Pull the two connectors on the dry side jet
pack through the large holes in the Inflatable Liner
(29). Push a Wet Side Gasket (48) onto each con-
nector. Thread a Wet Side Nut (49) onto each con-
nector and make sure it is tight.
4. Position the wet side jet pack (B) as shown. Place
an O-ring (52) in the groove of each connector on
the wet side jet pack. Note: Make sure the O-rings
are placed securely in the groove (see drawing
4A).
Attach the threaded collar on the right side (as seen
on drawing 4A) of the wet side jet pack (B) to the
corresponding connector on the dry side jet pack
(A). Attach the left side in the same manner. Note: If
the threaded collars are not tightened fully, the
spa will not function.
Position the Pillow (26) over the hole on the top of
the wet side jet pack (B). Push the fasteners on the
Pillow through the appropriate holes in the wet side
jet pack.
2
A
46
30
Small
Hole
Receptacle
47
9
29
3
A
29
48
48
49
9
Connectors
4
A
B
26
29
O-rings (52)
4A
O-rings (52)
Threaded Collar
View of Inside of Wet Side Jet Pack