Intel IP Media Server - Manual (Page 13)

IP Media Server for HMP Demo Guide — July 2005 13
2
2.
System Requirements
This chapter discusses the system requirements for running the IP Media Server for HMP demo. It
contains the following topics:
• Hardware Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
• Software Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
2.1 Hardware Requirements
To run the IP Media Server for HMP demo, you need:
• Intel ® Pentium ® III processor (minimum requirement). For detailed processor clock speed and
memory requirements, refer to the Release Guide (or Release Notes) for the HMP version you
are using.
• CD-ROM drive
• VGA display
• Pointing device (e.g., mouse)
• 100Base-T network interface card (NIC)
Note: A 1000Base-T NIC will yield better performance.
Memory Requirements
For production purposes, a minimum of 512 MB of memory is required. For development and
demo purposes using a low-end configuration, 256 MB of memory may be sufficient.
IP Endpoints
The following H.323 IP devices were tested for interoperability with HMP:
• Microsoft* NetMeeting* (Version 3.0 or later)
• Polycom* SoundPoint* IP 500
• Intel NetStructure ® PBX-IP Media Gateway
• Intel Optimizers Internet Phone
The following SIP IP devices were tested for interoperability with HMP:
• Polycom SoundPoint IP 500
• Intel NetStructure PBX-IP Media Gateway