Cornelius Door Latch - Manual (Page 4)

Door Latch Assembly Installation Instructions
Publication Number: 729011146INS - 4 - © 2004, IMI Cornelius Inc.
E. Insert slotted holes into new latch. F. Attach bracket and latch to cabinet frame
using (2) 6-32 x 3/8” screws and washers.
FIGURE 14
FIGURE 15
G. Close door and adjust cabinet bracket using
the 6-32 screws. Door should slightly com-
press the door seal.
H. Check lower and upper door to assure seal.
If not adjust bracket until it properly seals.
FIGURE 16
FIGURE 17
5. Connect cabinet interrupt switch jumper wire.
A. Plug one end of black spade end jumper in
each end of existing cable.
B. Wrap a piece of electrical tape on both ends
to prevent wires from coming loose.
FIGURE 18 FIGURE 19