Cornelius Door Latch - Manual (Page 5)

Door Latch Assembly Installation Instructions
© 2004, IMI Cornelius Inc. - 5 - Publication Number: 729011146INS
C. Route wires in existing cavity and reinstall insulation putty and replace tape.
FIGURE 20
FIGURE 21
D. Replace side panels by sliding panels for-
ward to engage panel tabs. Make sure plas-
tic spacers are located on panel clips before
assembling. Replace all screws that were
previously dissembled.
E. Replace latch cover plate.
NOTE: When reassembling latch guard use
the #8 PLASTIC screws supplied if holes are
stripped.
FIGURE 22
FIGURE 23
THIS COMPLETES THE LATCH ASSEMBLY PROCEDURE. If the machine is to use OPTION 1 “DOOR
RESET OPTION” allowing sold out to function complete the procedure by replacing all machine covers
and guards.
IF OPTION 2 IS SELECTED CONTINUE WITH PROCEDURE
6. Installing sold out defeat jumpers.
A. Remove screw, holding electrical box to
frame.
B. Pull control box from machine.
FIGURE 24 FIGURE 25