iHome Hidro-Fi iH2O - Manual (Page 4)

RESETRESET
TESTTEST
1:Opening and closing iH20
2
2:Power: AC or batteries
To charge and play iPod, attach AC adaptor cable to jack
on left of the iH20 (under rubber tab) and plug the other
end into a working AC outlet. Does not charge batteries.
For portable operation (in shower, etc.), open the battery
door located inside the unit above the iPod dock.
Install 4 AA batteries (match + and - polarity in diagram).
To open the unit, use thumb to push the two sliding lock
bars on either side UP to unlatch. To close cover, push
lock bars back down.
DC 7.5V
OPEN
LOCK
iH20 Quick Start
3:Inserts 4:iPod
Insert iPod into dock with proper insert.
Once iPod is docked, close the iH20.
When running on AC power, the iPod
will charge while docked. Press the Play
Button on the iH20 to play your iPod.
Install iPod Insert
Your iH20 comes with 3 removable inserts
and a card with rubber pads to ensure your
iPod fits properly in the iPod dock. Please
see insert table to select the insert that fits
your iPod. Make sure you are using the
correct insert for your iPod and that it is
properly docked into the iH20. Failure to do
so may damage your iPod.
To place an insert:
1. Select the insert for your iPod
2. Place the insert gently into docking bay.
3. Please note that iPod must not be in a
case or “skin”.
Note: This device will not control or charge
the 3G iPod.
ME NU
Use with
iPod Mini
iPod 4G 20 GB
iPod Photo 20/30 GB
* 5G iPodwith video 30 GB
Mini Insert Thin iPod Insert
Thick iPod
(no Insert needed) Nano Insert
iPod 4G 40 GB
iPod Photo 60 GB
* 5G iPod with video 60/80 GB
iPod Nano
2/4/8 GB
* To dock 5G iPod with
video, replace rubber pads
per instructions on the 5G
rubber pad card included