iHome Hidro-Fi iH2O - Manual (Page 6)

RESETRESET
TESTTEST
Using the iH20
Connecting iH20 to AC Power Source
a) Plug the AC adaptor cable into the
ᕩ AC Adaptor Jack on the left side of the unit
and the other end into a standard 120 VAC wall socket. If an iPod is properly
connected, it will begin charging, indicated by a flashing blue
ᕣ LED. The iH20
also operates on 4 “AA” batteries (see page 5 for information on installing/replacing
batteries) for portable playing. The AC adaptor charges the iPod with or without
batteries installed.
WARNING: DO NOT CONNECT TO AC OUTLET WHILE OPERATING IN
SHOWER
NOTE: To save battery life, when running off batteries the unit will automatically
power OFF after 2 hours of NON-use (no button activation). Press the
ᕤ
Play/ Pause Button to re-activate the unit.
Playing and Charging Your iPod
a) Place the proper insert (see page 2) in the dock and gently dock your iPod in the
unit. Make sure there is a power source (either batteries or AC power). Close the
case. The LED on the front panel will blink if unit is off and iPod is charging. Your
iPod recharges (until fully charged) while it is docked in the system and the iH20
is connected to an outlet with the included AC power adaptor. The iH20 does NOT
control or charge 3G iPod models.
NOTE: If you dock an iPod with a drained battery, it may take up to 6 minutes
of charging before the iPod will respond.
c) Press the ᕤ iPod Play/Pause Button to play your iPod, and again to pause.
d) Press ᕦ ᕢ + or - buttom to increase or decrease volume.
e) Press ᕥ Forward or ᕡ Reverse buttons to go to the next or previous track. Hold
ᕥ Forward or ᕡ Reverse while track is playing to scan to a given music passage.
ᕥ Forward and ᕡ Reverse do not affect components connected to the ᕧ line-in
jack.
f) Press and HOLD the ᕤ iPod Play/Pause button for 3 seconds to turn off the iPod and the unit.
NOTE: iPod will go to hibernation mode if iPod is off for sometime and not charging; you may need to press the
Play / Pause Button twice to play the iPod.
4
ME N U