Intermec Mobile PB3 - Manual (Page 14)

4 PB3 Mobile Printer User’s Guide
Using the Battery and AC Adapter/Charger
To install the battery
1 Slide the battery door latch toward the belt loop knob to unlock
the battery door, and open the battery door to an angle of about
90 degrees. Do not force the door all the way open.
2 Orient the battery so the arrow points toward the battery contacts
in the battery compartment.
Data and Status Off Card was read successfully, or card
cannot be read (for optional magnetic
stripe reader).
Steady Green Card reader is ready to accept data (for
optional magnetic stripe reader).
Flashing Red Printhead is too hot. Printing is paused
until printhead reaches normal
operating temperature.
Steady Red One of three conditions:
• Printer is out of paper.
• The paper door is open.
• Card reader error (for optional
magnetic stripe reader).
PB3 LED State Descriptions (continued)
LED State Description
Use Intermec battery model 318-040-001 only. Use of another
battery may present a risk of fire or explosion.
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not disassemble, heat above 80°C
(176°F), or incinerate.
Note: The battery must be cycled several times to achieve maximum
capacity. To cycle a battery, fully charge it and then allow a full
discharge through normal use. To ensure a full charge, do not operate
the printer while charging the battery.