Inter-Tel USER GUIDE 8525 - Manual (Page 70)

58 Inter-Tel ® Model 8524/8525 User Guide
MOVING ON
P
AGING
The Paging feature allows you to make an announcement through endpoint speakers
or external speakers (if your system is equipped with external paging equipment). To
prevent announcements from transmitting through every endpoint in the system, this
feature uses page zones. Each zone contains a different combination of extensions and
external paging equipment, and is programmed by your system administrator. Ask
your trainer or system administrator how the zones are programmed, and list them
below for your convenience.
NOTE: Although you can make pages from the Model 8664 and 8665, you cannot
receive them.
Enabling Paging
You can enable or disable page receiving for your endpoint by using the Page
Remove/Replace feature code. If your endpoint is assigned to more than one page
zone, all zones are removed or replaced at once (you cannot turn off individual
zones).
To turn paging on and off for your endpoint:
Press
and dial .
Making Pages
To make a page:
1. Press and dial .
2. Dial the desired zone number (0-9).
3. After the tone, make your announcement.
4. Press to hung up.
0 _______________________ 5 _______________________
1 _______________________ 6 _______________________
2 _______________________ 7 _______________________
3 _______________________ 8 _______________________
4 _______________________ 9 _______________________
START 3 2 5
START 7
END