Ice-O-Matic CD20030 CD20530 - Manual (Page 11)

CD10022 CD20030
CD10522 CD20530
Key Card Kit Installation
This kit has been designed for use with the
CD10022, CD10522, CD20030 and CD20530
ice dispenser. When this kit is installed, ice
cannot be dispensed unless a key card is
inserted into the key card slot.
The kit contains a universal mounting and a
microswitch assembly.
1. Make sure all electrical power is disconnected
to the dispenser before attempting to install this kit.
2. Remove the plastic molded front panel,
then remove the cover plate which is located below
the push button. This cover plate is held in place
3. Now disconnect wire #8 and #9 from
the normally open (NO) terminal of the
dispense switch (S2) and reconnect it
to the normally open (NO) terminal of
the room key microswitch.
Connect wire #6 supplied in the kit to
the normally open (NO) terminal of the
dispense switch (S2) and to the
common (C) of the room key
microswitch.
Reconnect all of the wires and terminals to
make sure the unit is wired correctly and all
terminal connections are tight and secure.
9
Electrical shock hazard.
Electrical shock can
cause personal injury.
Disconnect power before
begining to service
components.