Insignia NS-R2001 - Manual (Page 12)

10
Insignia NS-R2001 AM/FM Stereo Receiver
www.insigniaproducts.com
-OR-
Enter the preset number using the numeric
keypad.
Scanning preset stations in sequence
To scan preset stations:
1 Press the PRESETS button on the remote
control.
The receiver starts scanning the stations in the
preset sequence. Each station is sampled for five
seconds.
2 Press the PRESETS button again to stop
scanning.
Listening to FM stereo broadcasts
To listen to FM stereo broadcasts:
• While listening to an FM broadcast, press the
MONO/STEREO button.
Recording
Recording on AUX 1
To record on AUX 1:
1 Select the recording input source (this cannot
be AUX 1).
2 Start recording on the AUX 1 device.
3 Start play on your input device.
Recording on AUX 2
To record on AUX 2:
1 Select the recording input source (this cannot
be AUX 2).
2 Start recording on the AUX 2 device.
3 Start play on your input device.
Note
When using the numeric keypad on the remote
control, press the number you want. If your number is
greater than nine, enter the first digit, then enter the
second digit within two seconds.
Note
Each time this button is pressed, the FM mode
changes as follows:
• Stereo mode—ST lights up
• Mono mode—ST turns off.
Note
If an FM stereo broadcast is poor, due to a weak
broadcast signal, select the FM mono mode to
reduce the noise. The FM broadcasts are reproduced
in monaural sound.
Notes
• The volume, tone (bass and treble), and balance
settings have no effect on the recording signals.
• When you select tuner, CD, or PHONO as a
recording source, recording may be made on
AUX 1, or AUX 2, or both simultaneously.
OR
OR
NS-R2001_10-0038_MAN_ENG.book Page 10 Wednesday, February 3, 2010 7:36 AM