Insignia NS-RSW211 - Manual (Page 14)

14
Rocketboost™ Wireless Subwoofer
www.insigniaproducts.com
• 1 stereo HD quality + 3 CD quality -or-
• 2 stereo HD quality + 2 stereo CD quality -or-
• 3 stereo HD quality
Maintaining your system
Use a soft cloth dampened with a weak solution of mild detergent and
water. Dry the device immediately afterwards with a clean cloth. Do not
use abrasive cloth, thinners, alcohol, or other chemical solvents, because
they may damage the finish or remove the panel lettering.
Troubleshooting
Check this information for a possible solution before calling for assistance.
General troubleshooting
• Every Rocketboost network must contain only one hub device, which
helps other Rocketboost devices join the network.
• The wireless subwoofer must be wirelessly connected or joined
to the Rocketboost hub device (see “Connecting your
subwoofer for wireless mode” on page 11).
• You can turn any Rocketboost wireless sender or wireless
sender/receiver into a hub by using the HUB STATUS or HUB
ENABLE switch on the back of the device. The network can only
have one hub.
• The hub device must have power for the audio network to
operate. The hub can be in standby (power-saving mode), but
must remain plugged in.
• The existing hub device is the device with the green power
indicator.
• The unobstructed operating range of a Rocketboost network is 150 feet
(45 meters).
Note
HD streams are available if using the wireless sender from the
RF-RBKIT (Wireless HD Audio Starter Kit). If your system is in a
maximum audio stream state, then the Send mode indicator will
not light on the wireless sender devices that have exceeded the
maximum. To use those device's audio streams, turn off one of
your other wireless senders.
Cautions
• Do not block the ventilation openings.
• If the power cord is damaged, it must be repaired by a
qualified technician.
NS-RSW211_11-0334_MAN_V1.fm Page 14 Monday, May 9, 2011 7:01 PM