Insignia NS-P42Q10A - Manual (Page 15)

11
www.insigniaproducts.com
3 Connect this cable to a two-way splitter.
4 Connect the first coaxial cable between the
OUTPUT jack on the splitter and the INPUT jack
on the cable TV box.
5 Connect the second coaxial cable between the
ANT OUT jack on the cable box and the B–IN
jack on the RF (A/B) switch.
6 Connect the third coaxial cable to the other
OUT jack on the splitter and to the A–IN jack on
the RF (A/B) switch.
7 Connect the fourth coaxial cable between the
OUT jack on the RF (A/B) switch and the ANT IN
jack on the back of your TV.
8 Set the A/B switch to the A position to view
unscrambled channels, and set the switch to the
B position to view scrambled channels. (When
you set the A/B switch to the B position, you
need to tune your TV to the cable box’s output
channel, which is usually channel 3 or 4.)
Connecting satellite TV via a satellite TV box
You can connect a satellite TV box using an HDMI,
DVI, or component video connection. For more
information, see:
• “Connecting an HDMI device” on page 12
• “Connecting a DVI device” on page 12
• “Connecting a component video device” on
page 13
Connecting a VCR
To connect a VCR:
1 Turn off your TV and all connected equipment.
2 If the antenna or cable TV cable is connected to
your TV, disconnect the cable from your TV.
3 Connect the antenna or cable TV cable to the
ANT IN jack on the VCR.
4 Connect a coaxial cable (not included) between
the ANT IN jack on the back of your TV and the
ANT OUT jack on the back of the VCR.
5 Connect a video cable (not included) between
the AV IN 1 (Y/VIDEO) jack on the back of your
TV and the VIDEO OUT jack on the VCR.
6 Connect an audio cable (not included) between
the AV IN 1 R-AUDIO-L jacks on the back of
your TV and the AUDIO OUT jacks on the VCR.
7 Turn on your TV, then turn on the VCR.
Incoming cable
Splitter
Splitter OUT
INPUT OUTPUT
Cable box
Cable box
INPUT OUTPUT
RF (A/B)
switch Splitter
Cable box
RF (A/B)
switch
Splitter
Cable box
Splitter
ANT IN
TV back
Note
If the VCR is a “mono” (non-stereo) VCR, use a
Y connector to connect to the AV IN 1 R-AUDIO-L
jacks of the TV, or connect the audio cable to the
AV IN 1 R jack.
Back of TV
To
ANT
IN
on
V
CR
From ANT OUT on VCR to ANT IN on back of TV
Video cable
Audio cable
NS-P42Q-P501Q-P502Q-10A_09-0100_MAN_V1_English.book Page 11 Friday, March 20, 2009 3:11 PM