ICP DAS USA MSM-508 - Manual (Page 17)

Industrial Redundant Ring Switch – Managed Switch Console Manual
Release No. : 0804-V1 15
▓ ▓ ▓ ▓ COM1 [baud rate][data bit][parity][stop bit]
Description
The first serial port Com1 is assigned for RS232. This command enables you to set up the
transmission speed (baud rate),data bit (data bit), parity check type (parity) and stop bit
(stop bit).
The transmission speed parameter [baud rate] allows the following settings: 300, 600,
1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200. The port speed and device
speed must match.
The number of data bits can be 7 (for true ASCII) or 8 (for any kind of data, as this matches
the size of a byte),
The parity check code can be set to none (0), even (1), or odd (2). None (0) means that no
parity bit is sent at all. Even (1) means applying even parity check, each set of transmitted
bits must have an even number of set bits. Odd (2) means applying odd parity check, each
set of transmitted bits must have an odd number of set bits.
Stop bit is used in asynchronous communications to indicate the end of a piece of data.
Parameters
Parameter Description
baud rate Provides the baud rate (300 or 600 or 1200 or 2400 or 4800 or 9600 or 19200
or 38400 or 57600 or 115200)for your usage, default value is 115200
data bit Provides the data bit value(7 or 8), default value is 8
parity Provides the parity check type, none (0) , even (1), odd (2):, default value is 0.
stop bit Provides the stop bit (1 or 2), default value is 1.
Example