InStep RIDE N STRIDE - Manual (Page 4)

4
Step 2. Undo the two buckles on the sides and at the front end of the
trailer/stroller (Figure G). Then fold down fabric to expose the
framing (Figure H). Machine screw, nut, spacer and washer will be
attached to the side support rails (Figure I). Undo the machine
screw, nut, spacer and washer from the side support rails (Figure J).
Insert machine screw on the inside of the side support rail and push
through the holes in the side support rails. Once the machine screw
has extended through the side support rail, attach the black spacer.
Note: the curved side will be against the side support rail and the
flat side of the spacer will be against the lower frame. Next, insert
the machine screw through the lower frame.
Then, put the washer over the machine screw on the outside of
the lower frame and tighten down locknut (Figure K). Repeat this for
the other side. The assembly should be as follows: machine screw,
spacer, washer and locknut (Figure L).
FRAME ASSEMBLY
G
H I
J K L
Lower Frame
Machine Screw, Nut,
Spacer and Washer
Lower Frame
Nut Machine Screw
Black Spacer
Side
Support
Bar
Machine Screw
Spacer
Washer
Nut
Allen Head
Wrench
Lower Frame
Side
Support
Bar
Machine
Screw,
Spacer,
Washer,
Nut
Side Support Bar