Integra DTR-7.6/6.6 User Manual
Page 77
77
Advanced Setup
—Continued
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can specify the signal format as either PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or rewind-
ing a DTS CD, try the DTS setting.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Digital Input Signal Formats
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
]/[
]
buttons to select “2. Digital
Input,” and then press [Enter].
Setup
Receiver
Enter
3
Use the Up and Down [
]/[
]
buttons to select an input source
that’s assigned to a digital input
(opt, coax, or HDMI), and then
press [Enter].
The Digital Format menu appears.
4
Use the Up and Down [
]/[
]
buttons to select the input, and
use the Left and Right [
]/[
]
buttons to select: PCM, DTS, or
Auto.
PCM:
The PCM indicator flashes, and
only input signals in PCM format will
be output.
DTS:
The DTS indicator flashes, and
only input signals in DTS format will
be output.
Auto (default):
The format is detected
automatically. If no digital input signal
is present, the corresponding analog
input is used instead.
5
Press the [Setup] button.
Setup closes.
2-1.Digital Format
------------------------
a.DVD :Auto
b.VIDEO1 :Auto
c.VIDEO2 :----
d.VIDEO3 :Auto
e.VIDEO4 :Auto
f.TAPE :----
g.CD :Auto
h.PHONO :----