InFocus EC 10SB (SL) - Manual (Page 6)

— 6 —
EXTENSION CORD
Use only three-wire extension cords that have three-prong grounding-type plugs and three-pole receptacles that accept the
compressor’s plug. Replace or repair damaged cord.
Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and
overheating. Table shows the correct size to use depending on cord length and name plate ampere rating. If in doubt, use
the next heavier gage. The smaller the gage number, the heavier the cord.
MINIMUM GAGE FOR CORD SETS
Total Length of Cord in Feet (Meter)
0 – 25 26 – 50 51 – 100 101 – 150
(0 – 7.6) (7.9 – 15.2) (15.5 – 30.5) (30.8 – 45.7)
Ampere Rating Wire guage size AWG(mm 2 )
More Not More
Than Than
0 – 6 18 (1.0) 16 (1.5) 16 (1.5) 14 (2.0)
6 – 10 18 (1.0) 16 (1.5) 14 (2.0) 12 (3.5)
10 – 12 16 (1.5) 16 (1.5) 14 (2.0) 12 (3.5)
12 – 16 14 (2.0) 12 (3.5) Not Recommended
SAVE THESE INSTRUCTIONS
AND
MAKE THEM AVAILABLE TO
OTHER USERS OF THIS TOOL!
WARNING:
Avoid electrical shock hazard. Never use this compressor with a damaged or frayed electrical cord or
extension cord. Inspect all electrical cords regularly. Never use in or near water or in any environment
where electric shock is possible.