Intel FB24624100 - Manual (Page 67)

5: System Configuration
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 5•5
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
mPGA478B
LAN Controller
JPSKMV1
JATXPWR1
JCFAN1
JP2
U23 JCOM2
JP1
JGAME1
JATXPWR2
FDD1
IDE1,2
JCMOS1
JPANEL1
JDIMMVOLT1
JUSB1
JUSB3
JUSBV1
JSFAN1,2 J1
JCDIN1
JAUX1
JAUDIO1
AGP1
PCI1
PCI2
PCI3
DDR1 DDR2
mP4G
CPU1
Onboard IDE Connectors
Each channel connector
supports one IDE channel
with two drives, a Master
and a Slave. The Master
drive connects to the con-
nector on the end of the
ribbon cable. The Slave
drive connects to the con-
nector in the middle of
the ribbon cable.
Note:
The ribbon cable used
must support the transfer
mode of the fastest device
connected to it to avoid
degraded performance.
Floppy
connector
IDE1
Primary
Channel IDE2
Secondary
Channel
Floppy Drive Connector
The floppy drive connec-
tor supports two floppy
disk drives. The first drive,
Drive A:, connects to the
connector on the end of
the floppy drive connec-
tor cable. A second drive,
Drive B:, would connect to
the middle connector on
the cable although sys-
tems now commonly only
have one floppy disk drive.
FDD1
IDE1,2