Intel SE7520JR2 - Manual (Page 26)

Hardware Installations and Upgrades
4. Remove the server’s cover. See the documentation that accompanied your server chassis for
instructions on removing the server’s cover.
5. Locate the DIMM sockets (see Figure 5).
TP00761
DIMM 2A
DIMM 3B
DIMM 3A
DIMM 2B
DIMM 1A
DIMM 1B
Figure 5. Installing Memory
6. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open
position.
7. Holding the DIMM by the edges, remove it from its anti-static package.
8. Position the DIMM above the socket. Align the notch on the bottom edge of the DIMM with
the key in the DIMM socket. The arrow in the inset in Figure 5 is pointing to the key in the
socket.
9. Insert the bottom edge of the DIMM into the socket.
10. When the DIMM is inserted, push down on the top edge of the DIMM until the retaining clips
snap into place. Make sure the clips are firmly in place.
11. Replace the server’s cover and reconnect the AC power cord. See the documentation that
accompanied your server chassis for instructions on installing the server’s cover.
26