IBM 4685-K03 - Manual (Page 21)

Chapter 2 “Installing the keyboard”
This section explains how the Keyboard is installed on the IBM 4800 POS terminal.
_________________________________________________________________________________________
Installation for IBM 4800 POS terminal
This section explains how Keyboard is installed on the IBM 4800 POS terminal (also referred to
as the system device).
1. Connect the keyboard cable 5 to the keyboard.
Notes:
a. Turning the keyboard over and looking from the front side, connect the keyboard
cable 5 to the right side socket of the two connections.
Connector
Keyboard cable 5
b. If also installing the video display, it should be installed before going on to Step 2. After
the display is connected, continue with Step 2, “With the video display”. (See the
instruction manual that comes with the IBM 4800 POS terminal for more information
about how to install the video display.)
2. Plug the other connector on the keyboard cable into the system device as shown in the
following figure, routing it through the back side of the system device.
Chapter 2 Installing the keyboard 5