IBM H SERIES RS/6000 User Manual
Page 22
2. Set the power switches of the attached devices to On.
Note: When the system is plugged in but not powered on, the Power On LED
flashes slowly.
3. Press the Power On button.
1
4
3
2
When you press the Power On button, the Power On LED displays a steady
green light, and the system starts a POST (power on self test).
During POST, progress codes appear in the operator panel display.
4. If the Power On LED does not come on and there is no indication of power when
you press the Power On button, ensure that the power cord, located at the back
of the system unit, is plugged into a grounded electrical outlet. If this does not
solve the problem, go to Chapter 9 on page 9-1. If the LED is not flashing and
OK
is not displayed in the operator panel display, go to Chapter 6 on page 6-1.
For a more complete discussion of power on methods, see “System Power-On
Methods” on page 3-25.
1
Reset Button
3
Operator Panel Display
2
Power On Button
4
Power On LED
2-2
RS/6000 Enterprise Server Model H Series User's Guide