InFocus IN3102 User Manual

Page 3

Advertising
background image

2

Table of Contents

Introduction 3

Positioning the projector

5

Projector and device connector guide

6

Connecting a computer source

9

Required computer connections

(DisplayLink or VESA)

9

Optional computer connections

9

Displaying an image

10

Adjusting the image

11

Connecting a video device

12

Video device connections

13

Composite video connection

13

HDMI 1.3 connection

13

S-video connection

13

VESA connection

13

Component video connection

13

Shutting down the projector

14

Troubleshooting your setup

14

Using the remote control

22

Using the audio

23

Using the keypad buttons

24

Optimizing computer images

25

Presentation features

25

Optimizing video images

26

Customizing the projector

26

Using the menus

27

Basic Picture menu

28

Advanced Picture menu

29

Setup menu

30

Status and Service menu

32

Maintenance 33

Cleaning the lens

33

Using the security lock

33

Replacing the projection lamp

34

Important Operating Considerations for Safety

Place the projector in a horizontal position no greater than 15 degrees

off axis.

Locate the projector in a well-ventilated area without any obstructions

to intake or exhaust vents. Do not place the projector on a tablecloth or

other soft covering that may block the vents.

Locate the projector at least 4' (1.2 m) away from any heating or cooling

vents.

Use only InFocus-approved ceiling mounts.

Warning:

To prevent eye

injury if the projector is ceiling mounted, wear protective eyewear

before opening lamp door. A warning sticker is included with the user

documentation. Place this sticker on the lamp door if the projector is

mounted on the ceiling.

Only genuine InFocus lamps are tested for use in this projector.

InFocus is not liable for the performance, safety or certification of any

other lamps. The use of other lamps violates the projector warranty and

voids all certification marks on this projector.

Use only the power cord provided. A surge-protected power strip is

recommended.

Refer to this guide for proper startup and shutdown procedures.

Hg – Lamp contains mercury. Manage in accordance with local

disposal laws. See www.lamprecycle.org.

In the unlikely event of a lamp rupture, particles may exit through the

projector side vents. When the projector is turned on, keep people,

food, and drinks out of the "keep out" area under and around the

projector, as indicated by the "X" areas below.

Follow these instructions to help ensure image quality and lamp life over

the life of the projector. Failure to follow these instructions may affect the

warranty. For complete details of the warranty, see the Warranty Booklet.

5’

/ 1

.5 m

8’ / 2.4 m

3’

/ 1

m

2’ / 0.6 m

Advertising
This manual is related to the following products: