InFocus IN100 - Manual (Page 30)

Operation 30
Using Wall Color
In the situation where you are projecting onto a colored surface such as a painted
wall which may not be white, the
Wall Color feature can help correct the projected
picture’s color to prevent possible color difference between the source and
projected pictures.
To use this function, go to the DISPLAY > Wall Color menu and press / to
select a color which is the closest to the color of the projection surface. There are
several precalibrated colors to choose from:
Light Yellow, Pink, Light Green,
Blue, and Blackboard.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions
available when
User mode is selected. You can make adjustments to these
functions based on your needs.
Adjusting Brightness
Highlight Brightness in the PICTURE menu and adjust the values by pressing /
on the projector or remote control.
The higher the value, the brighter the image.
Likewise, the lower the setting, the darker the
image. Adjust this control so the black areas of the
image appear just as black and that detail in the
dark areas is visible.
Adjusting Contrast
Highlight Contrast in the PICTURE menu and adjust the values by pressing /
on the projector or remote control.
The higher the value, the greater the contrast. Use
this to set the peak white level after you have
previously adjusted the
Brightness setting to suit
your selected input and viewing environment.
+50 +30 +70
0 +30 -30