Integra DTR-8.8 - Manual (Page 97)

97
Adjusting the Listening Modes
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Direct Setting
Delay Enable
■ DSD
This setting determines whether or not DSD (SACD)
audio signals are passed through the DSP for A/V Sync,
delay, etc., processing when the Direct listening mode is
selected.
No: DSD signals are not processed by the DSP.
Yes: DSD signals are processed by the DSP.
Multiplex/Mono Settings
Multiplex
■
Input Ch
This setting determines which channel of a stereo multi-
plex source is output. Use it to select audio channels or
languages with multiplex sources, multilingual TV
broadcasts, and so on.
Main: The main channel is output (default).
Sub: The sub channel is output.
Main/Sub: Both the main and sub channels are out-
put.
Mono
■ Input Ch
This setting determines which channel is output when
the Mono listening mode is used with a stereo source.
L+R: Both the left and right channels are output
(default).
L: Only the left channel is output.
R: Only the right channel is output.
■ Output Speaker
This setting determines which speakers output mono
audio when the Mono listening mode is selected.
L/R: Mono audio is output by the front left and right
speakers.
C: Mono audio is output by the center speaker
(default).
PLIIx/Neo:6 Settings
PLIIx Music (2 ch Input)
These settings apply to only 2-channel stereo sources.
If you’re not using any surround back speakers, these
settings apply to Dolby Pro Logic II, not Dolby Pro
Logic IIx.
■ Panorama
With this setting, you can broaden the width of the front
stereo image when using the Dolby Pro Logic IIx Music
listening mode.
On: Panorama function on.
Off: Panorama function off (default).
Audio Adjust
1 Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “3. Audio
Adjust,” and then press [Enter].
The Audio Adjust menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select an item, and
then press [Enter].
The screen for that item appears.
4 Use the Up and Down [ ]/[ ]
buttons to select an option, and
use the Left and Right [
]/[ ]
buttons to change it.
The Audio Adjust menu items are
explained below.
5 When you’ve finished, press the
[Setup] button.
Setup closes.
Receiver
Setu
p
Enter
Enter
3.Audio Adjust
1.Tone Control
2.Direct
3.Multiplex/Mono
4.PL x/Neo:6
5.Dolby EX
6.Theater-Dimensional
7.LFE Level
Enter
Enter
Enter
Enter
Setu
p