Replacing heel loops, Raising/lowering elevating front riggings – Invacare Van Seat PHWH93 User Manual
Page 19
SECTION 6—FRONT RIGGINGS
19
3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest
support.
4. Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary.
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 6.4.
1. Note the position of hex bolt, coved
washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and
locknut that secure the existing heel
loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1‐6 to reassemble.
FIGURE 6.4 Replacing Heel Loops
NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 6.5.
1. Perform one of the following:
• Raising ‐ Pull back on the release lever and raise front rigging to the desired height.
• Lowering ‐ Support front rigging with one hand away from the release lever. Push
release lever downward with other hand.
FIGURE 6.5 Raising/Lowering Elevating Front Riggings
Coved
Washer
Hex Bolt
Footrest
Support
Coved
Washer
Locknut
Lower
Footrest
Phillips Bolt
Locknut
Spacer
Heel Loop
Release
Lever