JVC LVT1627-001A - Manual (Page 172)

46
ENGLISH
Menu items Selectable settings (Initial setting)
System Setting
Installation
Angle Select the angle of the unit measured by the supplied gauge. (See
also the Installation/Connection Manual.)
1: –5.0° to 1.0°
2: 1.0° to 6.0°
3: 6.0° to 14.0°
4: 14.0° to 32.0°
• It is not recommended to install the main unit at an angle of
more than 30˚; otherwise, the malfunction may result.
• Guidance is canceled when you change this setting.
WAAS/EGNOS Select whether to use WAAS and EGNOS to increase the accuracy
of positioning.
Off: Cancels.
On: Activates.
Language *5 Select the language used for on-screen information and voice
guidance.
Dansk, Deutsch, English UK, English US, Español,
Français, Italiano, Nederlands, Svenska
Reset Calibration Reset the calibration data in the following cases:
• When you reinstall the unit to another car.
• When you change Installation Angle.(☞ above)
• When you replace or rotate the tyres.
Once this is carried out, the calibration data is cleared. Calibration
starts when you exit from the menu. (☞ [9])
• Guidance is canceled when you reset the calibration data.
Measuring Units
Select the measuring units for distance.
km / m, mi / yd
Coordinates
Select the measuring units for coordinate degrees.
Deg / Min / Sec, Deg / Milli / Micro
Car Position
If you find your current position displayed on a wrong place on the
map, use this setting to correct your position.
Adjust the position with
4¢5∞, then the direction with 5∞.
Setup Menu (continued)
*5 This setting is shared with the Language setting in AV Menu (☞ [90]).
KDNX5000_E_eng.indb 46 KDNX5000_E_eng.indb 46 14/2/07 9:59:06 pm 14/2/07 9:59:06 pm