Jensen Hello Kitty KT7009A - Manual (Page 12)

12
1. Power off the camera and turn the camera SD Card slot faces you.
2. Inserting the SD card, ensuring you orient it correctly — please see the silkscreen beside the SD
card socket. To remove the SD card, push the SD card inside and the SD card is released from
the slot.
3. Power on the camera again and ready for picture shoot or video recording.
IMPORTANT:
The camera will be turned off automatically for protection if SD Card is inserted or removed when
the camera power is on.
Never insert any other object which is not SD card into the camera’s SD card slot. Doing so will
create the risk of damaging to the camera and the card.
Make sure that the terminals of the SD card are facing towards the same side of the LCD.
Should water or any foreign object ever get into the card slot, immediately turn off the camera and
then contact your dealer or nearest service provider.
Turning the Camera On and Off
To turn on the camera, fully press and hold the Power button until the power indicator lights up. Press and
hold the Power button again to turn off the camera.
Checking the Battery Level
Check the battery power level before taking pictures.
1. Turn on the camera.
2. Check the battery status level that appears on the LCD screen.
Batteries have adequate power.
Batteries have only limited power to support in a short time.
When running out of battery power, the icon will blink for 5 seconds and camera will be turned
off automatically. This indicates the battery need to be recharged.
Charging the internal Lithium Battery
A rechargeable battery is integrated in the camera. When the camera displays “ “ icon in blinking and
is turned off automatically, it means all the battery energy is used up. Please follow the following steps to
recharge the battery.
IMPORTANT:
Battery charging is active only when the camera power is switched off.
It is normal that the camera feels slightly warm while recharging the internal battery.