JVC TH-45 - Manual (Page 75)

13
English
5
A ctivate Realistic Sound Field
You can enjoy DSP modes.
DSP modes—HALL, THEATER, PAVILION,
DANCE CLUB, LIVE CLUB
DSP modes take effect only when you enjoy a disc recorded using
Linear PCM—the LINEAR PCM indicator lights up on the display.
To activate DSP modes
Press DSP MODE (or DSP on the front panel).
The DSP indicator lights up and the current DSP mode
appears on the display for a while.
• Each time you press the button, DSP mode changes as
follows:
– For in-depth information about DSP modes, see “Creating
Realistic Sound Fields” on pages 19, 23, and 24.
Note:
Before activating the realistic sound field, adjust the speaker setting to
bring out the best performance from this system.
For in-depth information about adjusting the speaker setting, see
“Speaker Settings” on pages 16 and 17.
6
Stop Playback
Press 7 twice.
Playback stops completely and “VCD” or “CD”
appears on the display. (The DVD player goes
on working for 3 minutes after playback stops.)
• This system can memorize the end point even
when you press 7 once. When you start playback again by
pressing 3/8, playback begins from where it has been stopped—
Resume play.
To remove the loaded disc
Press
0.
“OPEN” appears on the display and the disc tray comes out.
To close the disc tray, press
0 again.
• If you do not press the button, the disc tray closes
automatically after 35 seconds.
To turn off the power (into standby)
Press STANDBY/ON AUDIO (or
STANDBY/ON on the front panel).
The illumination lamp goes off and the STANDBY
lamp lights up.
• If you press STANDBY/ON
AUDIO (or
STANDBY/ON on the front panel) while the disc tray is kept
open, the disc tray closes automatically, then the system is turned
off.
• A small amount of power is consumed even in standby mode. To
turn the power off completely, unplug the AC power cord.
STANDBY/ON
AUDIO
HALL PAVILION THEATER
Normal
indication
(canceled)
LIVE CLUB DANCE CLUB
DSP MODE
Sound signal
indicators on the
display
TUNER PRESET
EN10-17TH-A5[C]f.pm6 01.12.25, 13:58 13