JVC TH-45 - Manual (Page 82)

20
English
Creating Realistic Sound Fields
B.SEARCH
REW FF
F.SEARCH
ENTER
VOLUME
VCR CHANNEL
TUNING
DVD FM/AM AUX MUTING
1 2 3
4 5 6
7 8 9
0
REMAIN
PROGRAM
D.R.C
SETUP
SLEEP
EFFECT
DSP MODE
TEST
PRO LOGIC
SETTING
SOUND
CLEAR
REPEAT
ANGLE
SLOW
SEARCH
A-B REPEAT
ZOOM
2 3
PRO LOGIC
SOUND
D.R.C
Adjusting Stereo Sound
You can adjust the following settings.
It is recommended that you make adjustments from your actual
listening point while listening to reproduced sounds.
– Output balance for the front speakers
– Output level for the subwoofer
Once you adjust these items, the adjustments take effect for all the
surround modes.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
1
Select and play any source except Dolby Digital
or DTS Digital Surround.
2
Cancel Dolby Surround or DSP modes if they are
activated.
For deactivating Dolby Surround:
Press PRO LOGIC on the remote control until
“STEREO” appears on the display.
For deactivating DSP modes:
Press DSP MODE (or DSP on the front panel)
until the DSP indicator goes off from the display.
Now, you are ready to start adjustments.
• To adjust the output balance for the front speakers, go to the next
step.
• To adjust the output level for the subwoofer, go to step
4
.
00 F 00 00 R 00 CEN
Normal indication
(canceled)
SW REAR
00 F 00 00 R 00 CEN
Normal indication
(canceled)
SW REAR
3
To adjust the output balance for the front
speakers
1) Press SOUND repeatedly until the
adjustment indication for the front
speakers appears on the display.
• Each time you press the button, the adjustment indication
on the display changes as follows:
2) Press
3 or 2 to adjust the
output balance.
3 : Decreases the left speaker
output, or restores the right
speaker output.
2 : Decreases the right speaker
output, or restores the left
speaker output.
• The output balance changes from
OFF (silence), –06 (most reduction) to 00 (no reduction).
• “00 F 00” is the initial setting (the output balance is at the
center position). If you have already changed the setting,
another value will appear.
4
To adjust the output level for the subwoofer
1) Press SOUND repeatedly to select
“SW.”
• Each time you press the button, the indication on
the display changes as follows:
2) Press
3 or 2 to adjust the
output level.
3 : Increases the output level.
2 : Decreases the output level.
• The output level changes from –06
to +06.
• “SW –06dB” is the initial setting.
If you have already changed the
settings, another value will appear.
DSP MODE
PRO LOGIC
SOUND
ENTER
ENTER
SOUND
DSP MODE
EN18-24TH-A5[C]f.pm6 01.12.25, 13:58 20