JVC HR-XVC27UM - Manual (Page 14)

Filename [XVC27UM_06Index.fm]
Masterpage:Left+
14
EN
Page 14 14 June 2004 4:20 pm
INSTALLING YOUR NEW UNIT (cont.)
Component Video
Connection
(DVD deck only)
8 To connect to a TV with component video input
connectors . . .
A
Connect the unit to TV.
A Connect the aerial, unit and TV as per “AV
Connection” (
੬
pg. 12).
B Connect the unit’s COMPONENT VIDEO OUT
connectors to the TV’s component video input
connectors.
B
Connect the unit to power source.
Plug the end of the AC power cord into an AC outlet.
C
Set the VCR channel to off.
A When the unit is turned off, press STOP (8) on the unit
for more than 5 seconds. “3 CH” appears on the front
display panel.
B Press CH +/– on the Remote to select “– CH” (off),
then press ENTER.
● If Plug&Play or Tuner setting has not previously been
performed, the Language Select screen appears and Plug&Play
takes place automatically.
NOTES:
● You can obtain high-quality component video pictures.
● If your TV is not stereo-capable, use the unit’s AUDIO
OUTPUT connectors to connect to an audio amplifier for
Hi-Fi stereo sound reproduction.
● To operate the unit with your TV using the Component Video
connection, set your TV to its AV mode. You can also use the
TV/VCR button on the unit’s Remote to set JVC TV to the AV
mode.
● For switching the TV’s mode, refer to the instruction manual of
your television.
● By using the component video connection, you can view the
images in the progressive mode. For switching to the
progressive mode, refer to “Scan Mode Set (DVD deck)”
(
੬
pg. 78).
ATTENTION
Be sure to connect the unit’s VIDEO OUTPUT (DVD/
VCR) connector to the TV’s VIDEO input connector.
TV
To Component Video
Input connector
Component
Video cable
(not supplied)
Audio/video
cable
(not supplied)
AC outlet
AC power cord
Back of unit
RF cable
(supplied)
COMPONENT VIDEO
OUT
Antenna or Cable
Matching transformer
(not supplied)
Coaxial cable
Flat feeder
AUDIO OUTPUT
VHF/UHF
OUT
VHF/UHF
IN
To 75 ohm
Terminal
VIDEO OUTPUT
Before performing the following steps:
● Make sure there is no cassette inserted in the unit.
● Make sure the unit is turned on, then press VCR/
DVD on the unit or VCR on the Remote so that the
VCR indicator lights up.
XVC27UM_06Index.fm Page 14 Monday, June 14, 2004 4:20 PM