Jura Capresso F707 - Manual (Page 10)

10
Ⅲ FILTER –
Ⅲ Turn the Rotary Switch (1) until the following message is displayed:
Ⅲ
HARDNESS
Ⅲ Now press the Rotary Switch (1) to start the programming.
Ⅲ
LEVEL 3
Ⅲ Turn the Rotary Switch (1) until the required level is displayed.
Ⅲ For example,
LEVEL 4
Ⅲ Press the Rotary Switch (1) to confirm the required level.
Ⅲ
HARDNESS
Ⅲ Turn the Rotary Switch (1) until
EXIT appears
Ⅲ Press the Rotary Switch (1) to leave the programming mode.
Ⅲ
READY
5. Installation of CLARIS plus filter cartridges
If the CLARIS plus filter cartridge is installed properly, descaling
of the coffee machine is no longer required. For more infor -
mation on the CLARIS plus filter cartridge refer to brochure
‘CLARIS plus. Hard on limescale. Gentle on your coffee
machine.’
5.1 Installing the filter
Draw off 1/2 litre of water to rinse filter completely. In order to
ensure perfect operation, close tap (14) only after the display
says
CLOSE TAP
Ⅲ Fold up the cartridge holder. Install the filter cartridge in the water
tank, applying a gentle pressure (Fig. 1).
Ⅲ Fold down the cartridge holder again until it engages audibly.
Ⅲ Fill the water tank with cold, fresh tap water and install it again.
Ⅲ Press the Rotary Switch (1) until
FILTER – / ߛ appears
Ⅲ
FILTER –
Ⅲ Press the Rotary Switch (1) to start the programming.
Ⅲ
NO –
Ⅲ Turn the Rotary Switch (1) until the following message is displayed:
Ⅲ
YES ߛ
Ⅲ Press the Rotary Switch (1) to activate the filter cartridge.
Ⅲ
INSERT
OPEN TAP
Ⅲ Put a sufficiently large container (at least 0.5 litre) under the Pro-
fessional Cappuccino Frother (15) (Fig. 10).
Ⅲ Turn the selector switch of the Professional Cappuccino Frother (15)
to the steam position (Fig. 20).
Ⅲ If not installed already, insert the CLARIS plus filter.
Ⅲ Open the steam / hot water draw-off tap (14) (Fig.12).
Ⅲ
RINSING
FILTER
Ⅲ CLOSE TAP
Ⅲ Close the steam/hot water draw-off tap (14), now the IM PRESSA will
heat up to coffee temperature.