JVC 0105KTH-MW-BJ - Manual (Page 13)

Masterpage:Right0
EN
13
Filename [XV38ASAG_04Index.fm]
Page 13 December 8, 2004 3:54 pm
INITIAL SETTINGS
Video Channel Set
Video channel (RF output channel) is the channel on which your
TV receives picture and sound signals from the unit through the
RF cable.
A
Access the Video Channel Set mode.
Hold down 8 on the unit until the front display panel
shows the following.
B
Set the TV system (RF Connection only)
Press PR + or – on the remote control to set the
appropriate TV system that matches the system of TV
being used (refer to the table below).
1:B/G 2:D/K 3:I 4:H
C
Set the video channel.
Press ENTER, then press PR – until the front display panel
shows “
– –” .
● Now the video channel is set to off.
Set your TV to UHF channel 36.
● If the two vertical white bars appear
clearly on the TV screen as shown on
the right, press ENTER and then go to
step
D.
● If the two vertical white bars do not
appear clearly, press ENTER and then
PR +
or – to set the unit to a vacant channel between 28 and
60 which is not occupied by any local station in your area.
(Example) If channel 50 is available in your area
Then set your TV to UHF channel 50 and check if the two
vertical white bars appear clearly on the TV screen ; if so, go to
step
D. If not, re-set the unit to another vacant channel and try
again.
NOTES:
● If you set the unit to a channel which is occupied by a local
station or has neighbouring channels that are occupied by
local stations, the picture reception quality will be affected
and some interference noise will appear on the TV screen. Be
sure to select a vacant channel which has no broadcast on
neighbouring channels.
● If you cannot obtain the two vertical white bars clearly with
any channel between 28 and 60, consult your JVC dealer.
D
Exit the Video Channel Set mode.
Press ENTER on the remote control.
● If Auto Set Up ( ੬
pg. 14) or Tuner Set (
੬
pg. 60) has not
previously been performed, the Clock Set screen appears and
Auto Set Up takes place automatically.
Before performing the following steps:
● Make sure there is no cassette inserted in the unit and the
power is off.
● Slide the TV/VCR/DVD switch on the remote control to the
right.
Major Countries/Areas TV System
New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand,
Malaysia, Iran, Saudi Arabia, Egypt,
Morocco, Lebanon, Iraq
B/G
China, Mongolia, Russia D/K
Hong Kong I
Australia H
With AV Connection
With RF Connection
With AV Connection
To view picture signals from the unit, set your TV to its
AV mode.
With RF Connection
The channel you have set in step
C above is your
video channel.
To view picture signals from the unit, set your TV to
the video channel.
XV38ASAG_EN_BOOK.book Page 13 Wednesday, December 8, 2004 4:00 PM