JVC CA-UXA7DVD - Manual (Page 64)

61
3
Select the source to record.
1) Press ¢ or 4 repeatedly to select the source.
• Each time you press the button, the source
changes as follows:
• When you select “FM” or “AM,” press SET, then
select a preset number by pressing ¢ or 4.
• When you select “AUX/MD”, set the timer
function of the external component as well.
2) Press SET.
The hour digit of the timer-on time starts flashing.
4
Press REV. MODE to select the reverse mode.
• When setting the Recording Timer while the unit is in
standby mode, you cannot change the reverse mode
even if you press REV. MODE.
In this case, the recording will start in the current
reverse mode.
• Each time you press the button, the reverse mode
changes as follows:
* will be shown during recording when you select
.
5
Set the timer-on time.
1) Press ¢ or 4 repeatedly to adjust the hour.
You can adjust the hour using the number buttons.
2) Press SET.
The minute digit starts flashing.
3) Press
¢ or 4 repeatedly to adjust the minute.
You can adjust the minute using the number buttons.
4) Press SET.
The hour digit of the timer-off time starts flashing.
Three timers are available—Recording Timer, Daily Timer
and Sleep Timer.
• Before using these timers, make sure the built-in
clock is set correctly (see page 17).
• When using the tuner as the source, preset stations in
advance (see page 26).
Using the Recording Timer
With the Recording Timer, you can make an unattended
recording.
• You can set the Recording Timer whether the unit is
turned on or in standby mode.
• To correct a misentry any time during the setting process,
press CANCEL.
• To exit from the timer setting mode during the setting
process, press CLOCK/TIMER repeatedly until the
source indication appears.
• When you want to record onto both sides of a tape, you
can set the reverse mode to do so. Recording
automatically stops after recording in the
2 direction.
Therefore, make sure that the tape direction is
3 when
recording with the reverse mode on.
How the Recording Timer actually works
The unit automatically turns on, muting the volume, and
starts recording on the tape when the timer-on time comes.
Then, when the timer-off time comes, the unit
automatically turns off (stands by).
The Recording Timer works only once, but the timer
settings remain stored in memory until you reset them or
unplug the AC power cord.
1
Press CLOCK/TIMER repeatedly until “REC
TIMER” appears in the main display.
The timer (
) indicator lights up and the REC
indicator starts flashing on the display.
• Each time you press the button, the timer mode
changes as follows:
2
Press SET.
The source name flashes in the main display.
Ex.: When you set timer-on time to 11:30.
Source indication
REC TIMER DAILY TIMER
Clock time
(canceled)
FM AM AUX/MD
Recording on
one side. Recording on
both sides once.
*
EN60_64UX_A7DVD[UJ].pm6 03.2.25, 8:53 PM 61