JVC CX-7000 Series - Manual (Page 111)

[Retransfer] Tab
The retransfer settings screen enables you to set the conditions of
retransfer to the card.
.
m
Front/Back side settings
m
Setting procedures
v
The vertical axis shown in the setting area indicates the retransfer
temperature, and the horizontal axis represents the retransfer
speed.
v
Click on the corresponding square to change the value. The
selected value is indicated by [*].
v
Setting a value toward the top right end increases the transfer
force. However, the stronger heat also increases the deformation
of the card.
v
The colors below serve as a rough indicator for selection.
Color Description
.
Green Standard value.
.
Light Blue Appropriate range. Recommended range when
selecting a value other than the standard value.
.
Yellow Card bend increases.
.
Blue Retransfer defect may occur.
.
Red Do not select these values.
Cautions:
v
The different colors serve as a rough guide. The optimal value varies
according to the card type as well as the environment in which the
printer is used. Adjust the setting according to the actual
environment.
v
It may take a while for printing to start when the retransfer
temperature is changed.
v
There is only one standard retransfer temperature. Altering the
retransfer temperature on one side changes the temperature on
the other side.
v
The range of optimal values varies according to the [Card Type].
You can change the card type in the [Media Setting] Tab.
v
If the card type varies across printers, set the card type to use
accordingly. The color of the setting area varies according to the
card type in use.
m
UV Speed
Setting for printing the retransfer film in two panels when UV ink is used.
It is used to set the speed of the retransfer heating roller during retransfer
of the UV ink.
This setting helps to increase the retransfer speed without affecting the
quality of the UV print.
m
Card Type
The appropriate value varies according to the type of card used. You
can change the card type in the [Media Setting] Tab.
For more details, refer to "Card Type" (A page 112) in the “[Media
Setting] Tab”.
m
[Update] button
Applies the selected value to the printer.
m
[Refresh] button
Displays the printer settings on the screen.
Setup
111