Jet Tools C US JMS-12SCMS - Manual (Page 12)

12
Assembly
Unlocking the Slide Carriage
Loosen the slide carriage lock knob (A).
When transporting or storing the miter saw, the
slide carriage (B) should always be locked in
position.
Releasing the Cutting Head
When not in use, lock the
cutting head in the down position. Failure to
comply can cause serious injury or damage
equipment.
Unlocking
1. Push down on the switch handle (page 10).
2. Pull out the hold-down latch (A, Fig. 2).
3. Raise the cutting head to the up position.
Locking
Note: When not in use, lock the cutting head in the
down position.
1. Push the cutting head down
2. Press the hold-down latch (A, Fig. 2) in to lock.
Important: Always use the carrying handles when
lifting or moving to avoid damage to the machine.
Installing the Dust Bag
1. Squeeze the metal collar wings (B, Fig. 3) of
the dust bag (A, Fig. 3).
2. Place the dust bag neck opening around the
exhaust port (C, Fig. 3), and release the collar
wings (B).
To empty the dust bag, remove from exhaust port,
open zipper on underside of bag and empty into
waste container.
Note: Check and empty bag frequently. Do not wait
for it to get full.
Figure 1
Figure 2
Fif
Figure 3