Jet Tools C US JMS-12SCMS - Manual (Page 20)

20
Presetting the Cutting Depth
The depth of cut can be preset for even and
repetitive shallow cuts.
Referring to Figure 21:
1. Pull hold-down latch (C) out.
2. Flip the stop plate (A) counterclockwise to the left.
3. Adjust the cutting head down (See Cutting
Head section) until the teeth of the blade are at
the desired depth.
4. While maintaining the cutting head in the
desired position, turn the stop knob (B) until it
touches the stop plate (A).
5. Recheck the blade depth by moving the cutting
head front to back through the full motion of a
typical cut along the control arm.
Figure 21
Rear Support Bar
Do not operate the saw without
the rear extension support bar. Failure to comply
may result in serious injury!
Loosen the two screws (A, Fig. 22) and extend the
rear extension support bar (B, Fig. 22) by sliding it
out, then tighten the two screws.
Figure 22
Laser Beam
The laser is turned on with a switch located on the
saw handle (C, Fig. 23). When left on indefinitely, a
sensor will turn the laser off after 20 minutes. The
switch must be reset (turned off for two seconds,
then on again) to restart.
The laser has no adjustments and should not
require adjustment. If adjustment should become
necessary, take the miter saw to an approved
service center.
•
Laser radiation. Avoid direct eye exposure.
Always un-plug miter saw from power
source before making any adjustments.
•
Laser Warning Label: Max output <1mW
DIODE LASER: 522-542nm, Complies with
21CFR 1040.10 and 1040. 11.
LASER RADIATION
A C UTION
LASER RADIATION
A C UTION
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS II LASER PRODUCT
MAX OUTPUT <1mW, DIODE LASER 522-542nm
COMPLIES WITH 21CFR 1040.10 AND 1040.11
CAUTION
Use of controls or adjustments
or performance of procedures other than those
specified in this manual may result in
hazardous radiation exposure.
The use of optical instruments
with this product will increase eye hazard.
•
Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to
repair this laser product, serious injury may
result. Any repair required on this laser
product should be performed by authorized
service center personnel.
A
B