Jacuzzi J-ALLURELuxury Bathing and Entertainment System - Manual (Page 10)

J-Allure
Skirt Installation
It is necessary to mount the skirt shell clips on the factory installed wood blocks located along the underside of the
rim. Mark hole locations on the blocks using clips as a template for correct hole spacing. Then drill a pilot hole 1/2"
deep using a 3/32" diameter drill. Use caution to avoid drilling through the bath rim. Secure the clips to the wooden
blocks as shown.
USING A SQUARE OR LEVEL, MARK THE
PERIMETER OF THE BATH ON TH FLOOR
BATH PERIMETER
8-5/8"
7/8"
2"
1-1/2"
1-1/2"
FINISHED SIDE
OF BLOCK
WALL
SKIRT BLADE
WOOD
BLOCK
SHELL CLIP
SHELL
SCREWS
(PROVIDED)
1/4"
SHELL CLIP
SKIRT
WOOD BLOCK
SCREW
WITH
HINGED
CAP
1/2"
FINISHED
FLOOR
3-1/2"
SKIRT BLADE
NOTE: SAME LEVEL
AS FINISHED FLOOR
Using a square or level, determine the location of the vertical drop from the bath rim at both ends and the center of
the bath. Locate the center wood block (provided) at the appropriate distance from the vertical drop, centering it
lengthwise with relation to the rim of the bath. The faces of the side blocks (provided) will be oriented along a line
from the center vertical drop point to the end vertical drop point. The blocks can be screwed, nailed or adhered with
adhesive to the floor. Make sure the finished sides of blocks are outward. Glue the skirt blade (1-1/2" x 79-3/4" white
acrylic strip) to the front of the wooden blocks.
Before attaching skirt, locate the CD/radio speaker and power connectors coiled under the bath rim. Uncoil and
connect the speaker and power connectors to the CD/radio. Also locate the green ground wire and connect to the
chassis of the CD /radio.
Slip the skirt up between the rim and the shell clips. While holding the skirt at the bottom, move it inward toward the
bath. Lift it up so there is 1/2" gap between the floor and the bottom of the skirt. While using shims to hold the skirt
up, attach the skirt to the skirt blade and wooden blocks with screws through the predrilled holes.
8
SPEAKER POWER
CONNECTORS