Jacuzzi J-ALLURELuxury Bathing and Entertainment System - Manual (Page 25)

Controlling Whirlpool Action
The whirlpool action in your bath is influenced by three factors – direction of flow, force of water, and force of air.
All baths manufactured by Jacuzzi Whirlpool Bath are equipped with fully adjustable PowerPro
® jets, which are
adjustable for all three factors. Some baths have additional directionally adjustable jets which can be adjusted for
direction and flow of air only.
Direction: To change the direction of the water flow, swivel the jet nozzle to the desired angle. The jets can be directed
individually toward any location on your body to provide a hydromassage. The jets can also be adjusted so that they
all point in the same direction (clockwise or counterclockwise) to circulate the water in a circular motion around the
bath, causing a total whirlpool effect.
Water Force: The high volume, fully adjustable jets can be adjusted to control the force of the water coming into the
bath. For robust action, increase the force of the flow by rotating the jet handles to the left (counterclockwise). For
a more gentle effect, rotate the handles to the right (clockwise). Never run the whirlpool system with all the jets
closed.
Force of Air: Two knobs located on the bath serve as controls for the air induction system. The intensity of the
hydromassage whirlpool action is determined by the amount of air inducted into the water. As the amount of air is
increased, the hydromassage action increases. For maximum air induction, rotate the control knobs fully counter-
clockwise to the largest circles. For fewer air bubbles, decrease the amount of air induction by rotating the control knob
clockwise. When the knobs are turned to the smallest circles, only water is being circulated.
TURN CLOCKWISE TO
REDUCE AIR FLOW
TURN COUNTER-CLOCKWISE
TO INCREASE AIR FLOW
AIR INDUCTION CONTROLS
DIRECTIONALLY
ADJUSTABLE
FULLY
ADJUSTABLE
JETS
23
CD/RADIO
Note: The remote for the CD/radio is not intended to be used inside the shower or in the bath.
Note: For units with AM/FM radios, the quality of AM reception will vary by locality. Jacuzzi Whirlpool Bath is not
responsible for the quality of AM reception.
NOTE: In order to hear the TV audio, the Pioneer CD Receiver AUX function must be setup to be ON.
To perform this setting:
• If the unit is on, press SOURCE and hold until the unit turns off.
• Press FUNCTION repeatedly until AUX appears in he display
• Select AUX on and off with . The status will be displayed: AUX :ON.
TV
For operation of the TV consult the manual enclosed.
Note: The remote for the TV is not intended to be used inside the shower or in the bath.