JobSite Systems LSW-6.5 - Manual (Page 6)

4
8. In unique situations where the bracket
must be located precisely next to a joist,
the bracket has “emergency” screw
holes located on its snap-on tabs. Break
away two of the outer mounting tabs on
the side you wish to affix, see Figure 3.
Notching the joist so the bracket lies flush
may be required.
9. Next, screw the bracket tab to the joist
using one of the supplied screws. NOTE:
Do not over-tighten the screw, doing so
could crack the bracket tab. Level the
bracket, then affix the other side of the
bracket assembly using the supplied
screws.
10. After the drywall is installed, cut a hole
in the drywall using the outside of the
circular bracket flange as a template.
11. Attach the frame to the bracket by
screwing the frame to the bracket using
the supplied screws. NOTE: Do not over
tighten the screws, this will distort the
frame and the grille will not fit.
12. The screws should pull the frame and
bracket together (sandwiching the
drywall) so that the frame is flush with
the wall surface.
13. Strip 1/4” of insulation from the end of
each wire.
14. Tightly twist the end of each wire until
no frayed ends remain.
15. Attach the speaker wires to the speaker
terminal connectors. Connect the
negative output from the amplifier to the
black terminal. Connect the positive
output from the amplifier to the red
terminal.
16. Insert the speaker into the frame and
snap it into place. See figure 2.
17. Optional: If you are installing the speaker
in a ceiling or are located in an
earthquake zone or want the added
security of screwing the speaker baffle
to the frame, follow the Important Safety
Instructions on page 5.
18. Repeat steps 1-17 for each speaker
being installed.
19. After making tonal adjustments on all
the speakers (LSW-6.5 only), install the
grilles into the speakers.
DS00387ACN_LSW-6_6.5.qxp 11/18/04 6:55 PM Page 4