JobSite Systems LSW-6.5 - Manual (Page 8)

6
SETTING THE BASS AND
TREBLE CUT SWITCHES
LSW-6.5 Loudspeakers ONLY
LSW-6.5 loudspeakers feature separate
baffle-mounted bass and treble controls for
fine-tuning after installation. Each control
provides for approximately 3dB of Bass or
Treble reduction. See figure 7.
Listen to a well-recorded piece of music at
the user’s favorite listening position. First,
listen for bass boominess, particularly when
the speaker is placed near a corner. Put the
Bass switch in the Cut position to correct
this. Secondly, listen for treble harshness
or ringing, particularly when the speakers
are placed in a room without carpet. Put
the Treble switch in the Cut position to
correct this.
REMOVAL OF GRILLE
AND SPEAKER
Removing the Grille
If the grille is already installed, remove it by
using a bent paper clip or the tip of a
corkscrew and pulling it away from the
frame. See figure 8.
Removing the
Speaker
Utilizing two small screwdrivers or two
needle nose pliers, release the snaps that
hold the speaker to the frame. Insert the
screwdrivers into the holes in the snaps
and exert force straight down (towards the
woofer), until the snaps release. Once the
snaps release, the speaker can be tilted
away from the frame to be removed. Do not
attempt to use the frame for leverage, as
this may damage the surface of the frame
See Figure 9.
PAINTING THE GRILLE
AND FRAME
Painting the Speaker Frame
The speakers must be removed prior to
painting the frames.
Painting the Grilles:
The grilles should be painted before they
are installed on the speakers. The best
results will be obtained by using a spray
gun or airless sprayer. Thin the paint, and
then apply several light coats. This
technique helps prevent clogging of grille
holes. Paint both sides of the grille.
Figure 8
Figure 7
DS00387ACN_LSW-6_6.5.qxp 11/18/04 6:55 PM Page 6