JVC SR-VD400U - Manual (Page 43)

EN
43
1 Load a D-VHS cassette
Make sure the window side is up, the rear label
side is facing you and the arrow on the front of
the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
● The VCR turns on automatically.
● The tape will run for a few seconds while the
VCR searches for the tape number. If the tape
number is found, it will be shown on the TV
screen if “SUPERIMPOSE” is set to “ON”
(
੬ pg. 59).
● The counter is reset automatically, however, it
is not completely reset to “0:00:00”.
● If the cassette’s record safety tab has been
removed, playback begins automatically.
2 Start playback
Press PLAY ( 3 ).
The “Password Plesae” screen is displayed.
The tape is running but the picture will not
appear.
3 Input password number
Press the 5-digit Namber keys
to input the password number,
then press OK.
“Password OK” screen is
displayed and becomes to
playback screen about 3
seconds.
To stop playback
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ).
To fast-forward (when it is not running)
Press FF ( ¡ ).
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press POWER.
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
IN F-1
+
POWER
STOP/EJECT
(
7/0)
1 2
REW ( )
FF ( )
VCR
TV
CABLE
/DBS
REW( 1)
2
FF(
¡)
CANCEL
3
3
3
Please input a password number when you playback the
tape on which the password was set up.
This VCR can check the tape condition during playback
(and recording), and realizes the best possible pictures.
NOTES:
● Press CANCEL, when you redo an input from the beginning
during a password input.
● If the password is different, “Password NG” will be displayed
as and the “Password Please” display again.
Password Plesae
* * * * *
[OK] [CANCEL]
Password Plesae
1 2 3 4 5
[OK] [CANCEL]
Password OK
«
VD400U-EN42-49 03.7.18, 1:07 PM 43