JVC XR-D400SL - Manual (Page 30)

Using as a CD -R/RW drive
26
XR-D400 [E] EN
LET0169-001A
To use the unit as a CD-R/RW drive
1 Press POWER.
Make sure the power indicator lights.
2 Press SCSI.
Make sure the SCSI indicator lights up.
3 Turn on the host computer.
Important notes
• Setting the SCSI mode to OFF during using the unit as a CD-R/RW
drive interferes with the operation of the host computer.
• Be sure to operate in the proper order as described above, or the unit
cannot be recognized.
NOTES
• Your computer system and SCSI devices should not be set up in near proximity to
a television or radio as they may cause interference with signal reception.
• Be careful not to set the same ID number to two SCSI devices attached to the same
host computer.
• Be sure to turn off the power supply before changing SCSI ID numbers.
• When you have reset the ID number of a SCSI device, be sure also to reset the host
computer.
• When the SCSI mode is set to OFF, the computer cannot recognize the unit.
• When you use the unit as a CD-R/RW drive, the audio functions (playback,
recording) do not work.
SCSI
Operation
POWER
0 OPEN/CLOSE
SCSI
POWER
1
11
2
12
3
13
4
14
5
15
6
16
1 TRACK ALL ERASE
OVER
OPEN/CLOSE SOURCE
SPEED REPEAT FINALIZE PROGRAM REC
4x 2x 1x
7
17
8
18
9
19
10
20
OPEN/CLOSE
REC/PLAY
SCSI AUTO REC
REPEAT
SPEED
POWER