John Lewis JLTDC11 - Manual (Page 25)

Important!
• The appliance should not be installed in an
environment such as a unheated garage or
outbuilding. The combination of high
humidity and low ambient temperatures
could affect the performance or the
appliance and therefore invalidate your
guarantee.
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The
appliance must therefore not be installed
on floors which are not resistant to high
temperatures.
• When operating the tumble dryer, the
room temperature must not be lower than
+5°C and higher than +35°C, as it may
affect the performance of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind
the lockable door, a sliding door a door
with a hinge on the opposite side to that of
the appliance in such a way that a full
opening of the dryer is restricted.
Removing transport
safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door
2. Pull off adhesive strips from inside
machine on top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Warning! If the appliance was not
transported in an upright position,
leave it to stand for 12 hours before
connecting it to the electricity supply
and using it for the first time, so that
the oil can flow back to the
compressor. Otherwise the
compressor could be damaged.
Electrical connection
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
25