JVC CA-DXU10 - Manual (Page 60)

5
@
Speakers
To connect the speaker cords
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: blue/red/white to (+) and
black to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the System.
• The supplied speakers and subwoofer are magnetically
shielded to avoid color distortions on TVs. However, if not
installed properly, it may cause color distortions. So, pay
attention to the following when installing the speakers.
– When placing the speakers near a TV set, turn off the
TV’s main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.
¤
Voltage selector (not applicable for
Australian models)
#
Power cord
Plug the AC power cord to a wall outlet.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
1Push 2Insert 3Release
From front right speaker (black/blue)
From front left speaker (black/blue)
From left matrix
surround
speaker
(black/white)
(not supplied)
From right
matrix surround
speaker
(black/white)
(not supplied)
From subwoofer
(black/red)
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing to the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
DO NOT plug in before setting the voltage
selector and all connection procedures are
completed.
Voltage mark
DX-U6[U].book Page 5 Monday, March 26, 2007 2:22 PM