JVC CA-DXU10 - Manual (Page 61)

6
Connecting a USB Mass Storage Class Device
You can connect a USB mass storage class device such as a
USB flash memory, hard disk drive, multimedia card reader,
digital camera, etc. to this System.
• You cannot connect a computer to the (USB memory)
terminal of the System.
Preparing the Remote Control
If the range or effectiveness of the remote control decreases,
replace both batteries.
Canceling the Demonstration
To start the demonstration, select DEMO START.
Changing the Color System and
Scanning Mode
You can select the video output to match it to the color
system of your TV (NTSC or PAL).
• If you connect a progressive TV through the
COMPONENT jacks, you can enjoy a high quality picture
by selecting progressive scanning mode.
• You can change the setting only while playback is stopped.
1
Enter the color system setting mode.
2
Select the color system and scanning mode.
3
Store the setting.
When using the remote
control,
point the top of the
remote control toward the
remote sensor as directly as
possible. If you operate it
from a diagonal position,
the operating range (approx.
5 m) may be shorter.
Caution
Do not expose batteries to heat or flame.
USB cable
(not supplied)
Main unit
R6(SUM-3)/AA(15F)
NTSC / PAL NTSC or PAL Interlaced scanning.
For a conventional PAL or NTSC TV.
NTSC PROG/
PAL PROG NTSC or PAL Progressive scanning.
For a progressive NTSC or PAL TV.
Main Unit
ONLY
2 sec.
DEMO OFF
DEMO START
Remote
ONLY INFO
SCAN MODE
VFP
2 sec.
PAL PAL PROG
NTSC PROG NTSC
ENTER
/SET
DX-U6[U].book Page 6 Monday, March 26, 2007 2:22 PM